C ard created using no stamped images.
Project Recipe
Measurements:
DSP - 4 3/16" x 5 1/2"
- 2 1/2" x 2 1/2" for Starburst circle
- 5 1/2" x 2 1/2" for envelope flap
Pool Party - 3 3/4" x 3 3/4" fpr stitched circle
Gold Foil - scrap for Sprig Punch
Crumb Cake - scrap for Sprig Punch
Petal Pink Ribbon - 5"
1 - Thread Petal Pink ribbon through the top 2 circles on the laser cut card and tie in a square knot.
2 - Attach the starburst punch circle to the Pool Party Stitched Circle.
3 - Using Sprig punch, punch one sprig from Gold Foil paper and one from Crumb Cake.
4 - Using the DSP that has all the printed birds, fussy cut one bird, Attach the Gold Spring to the top back of the bird and the attach the Crumb Cake sprig to the bottom back of the bird,
5 - Using dimensionals, attach the bird to the layered circles. Set this piece aside.
6 - Open the Laser Cut card (portrait orientation) and apply a thin coat of liquid glue around the outside edge of the card front. Attach the larger piece of DSP over the laser cut side, making sure it clears the scoreline so that the card will close with no obstruction.
7 - Attach the finished Bird Circle to the front of the laser cut card, positioning it just below the Petal Pink ribbon. Stamp your sentiment of choice on the inside of the card.
8 - Take the 5 1/2" x 2 1/2" piece of DSP and lay it under the envelope flap and trace the outline. Fussy cut the DSP and apply it to the top of the envelope flap with liquid glue.
You are finished!