T hinking of you/get well card made with Stampin' Up! products including one you can earn for FREE during Sale-A-Bration 2024.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer and Paper Snips Scissors:
- card from Lost Lagoon Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Pebbled Path Cardstock
- 3-1/2" x 3-7/8" of stippled gray and blue botanicals on white background design from Softly Stippled 12" x 12" Designer Series Paper, cut so the stems are vertical on the vertical rectangle
- 1-5/8" x 3-7/8" of brownish gray textile design from Softly Stippled 12" x 12" Designer Series Paper
- 1-1/4" x 2-1/2" from Basic White Cardstock
- flower cut out of the stippled gray and blue botanicals on white background design from Softly Stippled 12" x 12" Designer Series Paper
Adhere the large piece of botanical design Softly Stippled Designer Paper to the bottom of the Pebbled Path rectangle so a small amount of Pebbled Path shows on the bottom, left, and right sides.
Adhere the smaller piece of textile design Softly Stippled Designer Paper to the top of the Pebbled Path rectangle so a small amount of Pebbled Path shows on the top, left, and right sides and it overlaps the top of the botanical designer paper rectangle a tiny bit.
Cut a 4-1/2" piece of the Pebbled Path jute trim from the 2023-2025 In Color Jute Trim.
Lay the jute trim across the matted designer paper/cardstock rectangle so it covers the seam between the designer paper pieces. Fold the ends of the jute trim over and secure the jute trim in place on the back with strips of Tear & Tape Adhesive.
Remove the protective backings from the Tear & Tape pieces and add Stampin' Seal to the back of the Pebbled Path rectangle. Adhere to the front of the Lost Lagoon card.
Mount the "I know you will get through this" sentiment from the Perennial Postage Set on Block B. Ink it up with the Lost Lagoon Ink Pad. Stamp it in the center of the white rectangle.
Pick out the small rectangle die with scallops on both ends only from the Perennial Postage Dies. Put it on top of the stamped sentiment rectangle on a platform on your Stampin' Cut & Emboss Machine so it is centered over the sentiment. Run through the machine.
Use Stampin' Dimensionals to adhere the sentiment cut out to the front of the card so it is centered over the jute trim and is about 1/2" from the left side.
If you haven't already done so, cut out the flower from the Softly Stippled Designer Paper by hand using the Paper Snips Scissors.
Use Stampin' Dimensionals to adhere the cut out flower to the front of the card so it overlaps the right side of the sentiment cut out and is centered over the jute trim. There should be about 1/2" of space between the right side of the flower cut out and the right side of the card.
Cut a 2-1/2" piece of the Pebbled Path jute trim from the 2023-2025 In Color Jute Trim.
Slide one end of the jute trim under the jute trim already on the card front on the right side of the flower cut out. Tie in place with a half knot. Trim and tease apart the ends.
Use the mini spatula on the Take Your Pick to carefully peel up 1 large Garden Green or Pretty Peacock pearl from the sheet of Blooming Pearls making sure that you get the adhesive backing as well. Adhere it to the top left corner of the card as shown.