F un thank you card using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Balmy Blue Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Garden Green Cardstock
- 3-7/8" x 5-1/8" of white and green pine trees and white snowflakes on blue background design from A Walk In The Forest 12" x 12" Designer Series Paper, cut so the trees are vertical on the horizontal rectangle
- 3-1/4" square from Basic White Cardstock
- 2-1/8" x 2-3/4" from Basic White Cardstock
- 1-1/2" x 2" from Balmy Blue Cardstock
Adhere the designer paper rectangle to the center of the Garden Green rectangle and then to the front of the Balmy Blue card.
Pick out the large, detailed, flying owl die from the Winter Owls Dies. Put it on top of the white square on a platform on your Stampin' Cut & Emboss Machine. Run through the machine. Use the paper-piercing tool and Take Your Pick Die Brush Tip on the Take Your Pick to remove the pieces.
Pick out both of the large, detailed, wing dies from the Winter Owls Dies. Put them on top of the white strip on a platform on your Stampin' Cut & Emboss Machine. Make sure the dies do NOT overlap. Run through the machine. Use the paper-piercing tool and Take Your Pick Die Brush Tip on the Take Your Pick to remove the pieces.
Use Multipurpose Liquid Glue or Fine-Tip Glue Pen to adhere the wing cut outs to the back of the owl cut out so they stick out from behind the wings as shown.
Use Stampin' Dimensionals and Mini Stampin' Dimensionals to adhere the owl cut out with wing cut outs attached to the front of the card as shown.
As you are ready to stamp using the Charming Sentiments Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Mount the "thank you" sentiment from the Charming Sentiments Set on Block B. Ink it up with the Garden Green Ink Pad. Stamp it on the small Balmy Blue rectangle.
Pick out the matching "thank you" die from the Sentiment Silhouettes Dies. Put it on top of the stamped sentiment on a platform on your Stampin' Cut & Emboss Machine so it is centered over the sentiment. Run through the machine.
Use Stampin' Dimensionals to adhere the sentiment cut out to the upper left corner of the card front as shown.
Use the mini spatula on the Take Your Pick to carefully peel up 5 small and large blue sequins from the sheet of Adhesive-Backed Glitter Sequins making sure that you get the adhesive backings as well. Adhere them to the card front as shown.