H ere is a fun way to display your beautiful patterned paper that uses every bit of each 4" x 6" piece. Thank you to Rachel Tessman for the idea!
Project Recipe
Cut all paper:
~Cut down a piece of designer series paper that is patterned to 4" wide by 6" tall. This makes 6 card fronts for each piece of dsp. Be sure pattern is oriented for vertical/portrait. Cut a 3/4" piece off of bottom. Put dimensionals across this 3/4" strip.
~Cut card base, this one was Pear Pizazz- 4 1/4" x 11". On long side, score at 2 3/4" and 5 1/2".
~ Basic white cardstock- 4" wide x 3 3/4" high, for inside
~Mossy meadow cardstock- 2" x 4 1/4", die cut the lattice out of this piece.
~1 1/8" x 3 5/8" piece Pear Pizzaz cardstock, cut out the largest banner piece from Stylish Shapes dies.
Stamp in Mossy meadow ink: Onto banner, stamp "WOO HOO!"
~Stamp you've got this onto basic white piece with the orientation of white having 4" as width and 3 3/4" high.
~Stamp in black ink the rose from the "Wonderful World" set on the bottom right portion of the basic white piece. Color image with blends.
~Punch two of each image from the Boughs punch from the Pearlescent specialty paper.
~Cut ribbon to 9"
~Make a knot on one end of ribbon and cut off.
~Put glue dot onto one end of ribbon. Adhere to front of dsp in the center down approximately 3/4". Wrap around and press other end of ribbon onto the center of the front where first end was secured.
~Use a glue dot and adhere knot onto the front where the two ends were glued down. Use knot to cover up[ those glued ends.
~Use liquid glue to adhere dsp onto the bottom half of the card front.
~Adhere lattice diecut onto inside bottom portion of card.
~Use seal plus on back of white inner piece. Put it onto the two sides. Use this to adhere the 1/4" strips to the side so a 1/16" part only shows on front of each side.
~Adhere this onto inside upper portion of card.
~Adhere WOO HOO piece onto cardfront with any desired adhesive.
~Tape or adhere the two smaller bough punch pieces onto the back of the patterned dsp piece used as the support of the easel. Adhere one punch to show on upper left of dsp and one on lower left of piece. Press down onto card inside approximately 1 1/8" up from bottom.
~Tape down the two largest punched embellishments onto the back of the WOO HOO banner piece. Position one on upper left portion at an angle and one at bottom right at an angle.
~Adhere this onto card front.